Thingiverse
DIY Parallel Lipo Charging Adapter 4S by John28
by Thingiverse
Last crawled date: 4 years, 7 months ago
Small and handy parallel charging adapter for 4S Lipos.
I recommend printing in PETG for durability.
Needed parts:
Female XT60 Plug
Pin headers (standard 2,54mm / 0.1in spacing)
Female pin header or some old balance plug
Piece of strip board (43x20mm)
Some wire
Note:
Before starting to charge leave the Lipos plugged in a few minutes to equalize their cell voltage. Don't mix full and empty batteries, as high compensating currents can cause damage!
I recommend printing in PETG for durability.
Needed parts:
Female XT60 Plug
Pin headers (standard 2,54mm / 0.1in spacing)
Female pin header or some old balance plug
Piece of strip board (43x20mm)
Some wire
Note:
Before starting to charge leave the Lipos plugged in a few minutes to equalize their cell voltage. Don't mix full and empty batteries, as high compensating currents can cause damage!