Thingiverse
DIY Onewheel pressureplate
by Thingiverse
Last crawled date: 5 years, 3 months ago
New sensor/pressureplate design for the DIY Onewheel project from Ddirito. It replaces the bending pressure plate from the original design because I couldn't get it to work as reliable as I wanted.
This is a rigid plate that uses the original footsensor buttons of the Hoverboard. The buttons drop right into the top of the plate. All you have to do is clip 5mm of the bottom of the button because it would otherwise be too long.
In practice I only use the button closest to the wheel but I didn't want to adjust the rest of the files. I made 13mm round holes in the griptape and the button is firmly stuck between the pla and the tape. No screws needed so far.
https://youtu.be/5VJzAjO545w
This is a rigid plate that uses the original footsensor buttons of the Hoverboard. The buttons drop right into the top of the plate. All you have to do is clip 5mm of the bottom of the button because it would otherwise be too long.
In practice I only use the button closest to the wheel but I didn't want to adjust the rest of the files. I made 13mm round holes in the griptape and the button is firmly stuck between the pla and the tape. No screws needed so far.
https://youtu.be/5VJzAjO545w