Thingiverse
Dirt digging claws for the garden glove
by Thingiverse
Last crawled date: 5 years, 9 months ago
There are two versions one direct to be able to print without support, and angled one allowing the better protection for the finger (see picture to support & tip strengthening needed)
The stl-files are solid. This allows better scaling the objects with the slicer.
The baseline inside size width is 22mm with 1.2mm wall. Fits thin size8 glove's middle finger. -5% pinkie and -3-2% for the ring & index ones.
On the slicer
1) scale STL for the desired size
2) select number of the walls (3-4) a bit over extruding & heat will make part stronger & zero infill
3) Zero ('0') bottom layers
The stl-files are solid. This allows better scaling the objects with the slicer.
The baseline inside size width is 22mm with 1.2mm wall. Fits thin size8 glove's middle finger. -5% pinkie and -3-2% for the ring & index ones.
On the slicer
1) scale STL for the desired size
2) select number of the walls (3-4) a bit over extruding & heat will make part stronger & zero infill
3) Zero ('0') bottom layers