Thingiverse
Dimensional test print by WaveSupportApparatus
by Thingiverse
Last crawled date: 4 years, 10 months ago
This is a simple object for interrogating the dimensional accuracy of your printer. I accept 1 layer height of variation as being within the acceptable range (e.g. ± 0.20 mm).
It takes about 12 minutes to print at 70 mm/s, 0.40 mm nozzle, 0.2 mm layer height.
Dimensional accuracy is less important than getting enough plastic down. Calibrate your flow rate correctly to figure this out.
It takes about 12 minutes to print at 70 mm/s, 0.40 mm nozzle, 0.2 mm layer height.
Dimensional accuracy is less important than getting enough plastic down. Calibrate your flow rate correctly to figure this out.