Thingiverse
Dewalt DWS709 Insert by drfinefrock
by Thingiverse
Last crawled date: 4 years, 1 month ago
This is an insert designed for my Dewalt 12 inch Sliding Miter Saw Model DWS 709.
To print the full size model you will need a bed that can print a 333 mm long model. I have cut the model in half so it may be printed on a smaller bed. Two options to choose from, with a slot and without a slot. The Slot is about 3/16" or 4.76 mm wide. I chose to Print the model without a slot and cut the slot with the saw and I use a Thin Kerf blade. When cutting with the saw some melted above the slot. I ran a very sharp chisel down the top side to remove the melted material.
Although not tested, the half models may be glued together with CA glues after printing.
To print the full size model you will need a bed that can print a 333 mm long model. I have cut the model in half so it may be printed on a smaller bed. Two options to choose from, with a slot and without a slot. The Slot is about 3/16" or 4.76 mm wide. I chose to Print the model without a slot and cut the slot with the saw and I use a Thin Kerf blade. When cutting with the saw some melted above the slot. I ran a very sharp chisel down the top side to remove the melted material.
Although not tested, the half models may be glued together with CA glues after printing.