Thingiverse
Danfoss RAV to M30 Adapter by toto-w
by Thingiverse
Last crawled date: 5 years ago
I printed the original part in PLA+ (tempered) and after 2 days the thread tore off. I decided to print the part in PETG and reinforced it a bit.
You may need the +1 mm pin also.
Print in 0.1 layer hight and 100% infill.
Print it hot and slow to get maximum layer adhesion.
Use support (I used tree suport).
I also set "Horizontal Expansion" to -0.3 in Cura to make it easy fit.
You may need the +1 mm pin also.
Print in 0.1 layer hight and 100% infill.
Print it hot and slow to get maximum layer adhesion.
Use support (I used tree suport).
I also set "Horizontal Expansion" to -0.3 in Cura to make it easy fit.