Thingiverse
D-bot Voron Afterburner mount by ParadoxX3D
by Thingiverse
Last crawled date: 4 years, 6 months ago
D-Bot mount for the Voron afterburner hot end assembly.
You will still need the required m3 heat set inserts, everything else is as the regular voron afterburner build.
I would suggest 4-5 perimeters, also for top and bottom layers with at least 50-60 infill
The x carriage part does mount on the back, but is not necessary if you go for 10mm shorter bolts
Warning: Print head will be 20mm short to the bed in comparison to the stock print head. You'll have to raise your bed.
**This model does not support the proximity sensor used with the afterburner (PL-08N) unfortunately.
Will be updating soon with pictures
You will still need the required m3 heat set inserts, everything else is as the regular voron afterburner build.
I would suggest 4-5 perimeters, also for top and bottom layers with at least 50-60 infill
The x carriage part does mount on the back, but is not necessary if you go for 10mm shorter bolts
Warning: Print head will be 20mm short to the bed in comparison to the stock print head. You'll have to raise your bed.
**This model does not support the proximity sensor used with the afterburner (PL-08N) unfortunately.
Will be updating soon with pictures