Thingiverse
CZ Scorpion Evo Triggers by Semper1371
by Thingiverse
Last crawled date: 4 years ago
A flat trigger with grip grooves and a slightly curved flat trigger for the CZ Scorpion EVO platform. These triggers should be printed so the print bed and the trigger face (where your finger goes) are touching. Supports are needed for the inside of the trigger since the
Using ABS and 50% fill I had a slight fracture at the top of the trigger that may cause problems down the road so be aware of that when printing. Nylon will probably be the better way to go about doing this or maybe even using a strengthening coat over it and re-drilling the roll-pin hole (which is about 1/8").
Changelog
1.04 - Finalized printable design, holes weren't aligning properly.
Using ABS and 50% fill I had a slight fracture at the top of the trigger that may cause problems down the road so be aware of that when printing. Nylon will probably be the better way to go about doing this or maybe even using a strengthening coat over it and re-drilling the roll-pin hole (which is about 1/8").
Changelog
1.04 - Finalized printable design, holes weren't aligning properly.