Cyclone Shield (Drone Turn-Over Protection)

Last crawled date: 4 years, 4 months ago

This Project is still experimental!!!
Note: since this is a drone build, precision is needed, the model works, by clipping on the prop guard, too loose and it might not snap on or the propeller may collide with the clip, to tight and it might be difficult or cant clipped on.
model used is for makerfire armor 65lite
pod (or pod v1)
-this is what we shared in some groups, as the test fall, it does do the job of keeping the drone upright
:issue, we tested this with PLA, and for some reason the main clips breaks when it gets hit directly
Pod V1.2 (deleted)
Modification: we strengthen the clip,
reason: but the propeller is blocked.
Pod V1.3.1
Modification: we strengthen the clip and lessen the mass on the top clip to avoid hitting the propeller
NOTE: the model was measured for a maker fire frame and propeller, larger propeller may still collide. this model will still collide with an eachine stock propeller
Pod V1.3.1 "SINGLES" <<-this is same as 1.3.1, but can be printed as singles, so if the PLA broke, you can just replace it.
-then its also easy to print alot in a singles
-since the profile is 2d, it can be resized abit from a slicer to match clip width
//our test is using PLA test. for any possible improvements, let me know.