Customizable Miniatures Base by azound

Last crawled date: 3 years ago

A parametrized base for miniatures models. Supports setting the diameter and taper angle. Can choose between solid (filled in on the bottom) or not (Only prints the outers edges). Can additionally cut a rectangle out of the base for slotting in models or add text to the base.
If printing a flat top you can print it upside down. If adding text on top, print it face up in solid mode.
Parameters:
base diameter - the base of the diameter in mm (e.g. 25)
height - the base height in mm (e.g. 5)
taper degrees - the angle of the base edge. 0 = vertical walls (e.g. 10)
slot width - If not 0, specifies the width of a rectangle to cut in mm (e.g. 5)
slot length - If not 0, specifies the width of a rectangle to cut in mm (e.g. 15)
thickness - The thickness of the walls in mm (when not using solid mode) (e.g. 1.5)
solid - If True, prints a solid base (useful when adding text on top) (e.g. False)
text message - Text to print on base (e.g. "?")
text size - The font size in mm (e.g. 4)
text depth - The height of the text in mm (e.g. 3)
text font - The font to use (e.g. "Liberation Mono")