Thingiverse
Custom UART 2102 Interface Case with 'cheat" window by Trezhunter
by Thingiverse
Last crawled date: 4 years, 1 month ago
Updated version of design by gnabeyama: http://www.thingiverse.com/thing:136359
This version uses that one's lid, so you'll need to download:
"usb_case_top_repaired.stl", (I've added a copy on the Thing Files page as of 3/1/2015)
Customized this to fit one of the newer 6-pin USB UART 2102 Adapters floating around ebay for a mere .45 cents.
Changes include:
raised walls to accommodate higher pin-headers.
moveable board-retainer that prevents the chip from receding into the case when USB port is plugged in.
& a cheater's window on the bottom so you can see which pins are labelled which without the need to remove the case.
5/7/14 - Update:.
Uploaded an STL version per franic's request.
Uploaded v2 "customuart_with_window-a-v2",Thing and .STL
v2 revision notes:longer window (so you don't mix up voltage)improved visibility (window view-angle)
1/31/15 - Update:.
Uploaded "custom_uart_openwindow-v3.stl" an open-window reference version intended for those who can't make the window adjustments or get this to print with a window, also tweaked the design slightly..
v3 revision notes:fully open window (non-adjustable .stl)more efficient print (quicker to finish, less filament)
v3.1 - minor fixes to bridge over the usb port.
This was my first design here. with literally less than 24-hours of 3d printing under the belt.. (nonstop, of course!)
This version uses that one's lid, so you'll need to download:
"usb_case_top_repaired.stl", (I've added a copy on the Thing Files page as of 3/1/2015)
Customized this to fit one of the newer 6-pin USB UART 2102 Adapters floating around ebay for a mere .45 cents.
Changes include:
raised walls to accommodate higher pin-headers.
moveable board-retainer that prevents the chip from receding into the case when USB port is plugged in.
& a cheater's window on the bottom so you can see which pins are labelled which without the need to remove the case.
5/7/14 - Update:.
Uploaded an STL version per franic's request.
Uploaded v2 "customuart_with_window-a-v2",Thing and .STL
v2 revision notes:longer window (so you don't mix up voltage)improved visibility (window view-angle)
1/31/15 - Update:.
Uploaded "custom_uart_openwindow-v3.stl" an open-window reference version intended for those who can't make the window adjustments or get this to print with a window, also tweaked the design slightly..
v3 revision notes:fully open window (non-adjustable .stl)more efficient print (quicker to finish, less filament)
v3.1 - minor fixes to bridge over the usb port.
This was my first design here. with literally less than 24-hours of 3d printing under the belt.. (nonstop, of course!)