Thingiverse
Creality CR-10 Z-Stepper Motor Clamp by Razurel
by Thingiverse
Last crawled date: 4 years, 7 months ago
Reason of redesign: the Z Axis Lead Screw was not in the middle with original distance holder
Z-Axis Steppermotor clamp for CR-10.
No additional screws needed.
Original top screws are little too long, use a spacer or washer or a bigger nut or redesign it.
(watch out for the free movement of heat bed )
Nozzle Temp: 200°C (PLA)
HeatBed : 55°C (Printing on glass with 3DLac-Spray)
Infill: 30%
Default Printing Speed: 2000 mm/min
Sliced with S3D
Z-Axis Steppermotor clamp for CR-10.
No additional screws needed.
Original top screws are little too long, use a spacer or washer or a bigger nut or redesign it.
(watch out for the free movement of heat bed )
Nozzle Temp: 200°C (PLA)
HeatBed : 55°C (Printing on glass with 3DLac-Spray)
Infill: 30%
Default Printing Speed: 2000 mm/min
Sliced with S3D