CR-10S 400/500 Y-Axis Stepper Brace

Last crawled date: 5 years, 2 months ago

This is a remix from Hamkers bracket for the regular CR-10s. The S400 has two bed cross supports which interfered with the original bracket. The S400/S500 Y-axis stepper motor is also located closer to the frame, so this bracket also accounts for that.
Without the brace, I noticed my Y stepper motor was angled quite a bit away from the frame after I tightened the belts. it caused the belt gear to also be at an angle, I got some ringing on my prints due to the stepper moving a bit when the build plate changed directions. This bracket completely fixes those issues.
I made (2) versions, one short, one long. Both should work the same, so it's up to you which one you like better.