Thingiverse
Cr-10 Control Box remake V2 by kevinrocksman
by Thingiverse
Last crawled date: 4 years, 1 month ago
I have tested every part of this besides to mainboard and octopie covers but other than that this is good to go.
A redesign of the cr-10 power/control box. Not sure of screw sizes because i forgot to write them down but everything should fit together snugly. It was designed with a .2mm tolerance between parts.
EDIT V1.1 - Modified the Bottom-Back, had the wrong screw mount points for the PSU
EDIT V1.2 - Modified the top back lid to have a fan for the heat bed relay/voltage regulator, realized it generated a bit more heat than anticipated for long heatups
EDIT V1.5 - Printed bottom back, bottom front and bottom lid back. Made a few small changes due to psu hols being wrong
EDIT V2 - Printed and tested every part besides the mainboard and octopi covers. Everything has been updated on everything i found wrong with the original setup.
A redesign of the cr-10 power/control box. Not sure of screw sizes because i forgot to write them down but everything should fit together snugly. It was designed with a .2mm tolerance between parts.
EDIT V1.1 - Modified the Bottom-Back, had the wrong screw mount points for the PSU
EDIT V1.2 - Modified the top back lid to have a fan for the heat bed relay/voltage regulator, realized it generated a bit more heat than anticipated for long heatups
EDIT V1.5 - Printed bottom back, bottom front and bottom lid back. Made a few small changes due to psu hols being wrong
EDIT V2 - Printed and tested every part besides the mainboard and octopi covers. Everything has been updated on everything i found wrong with the original setup.