Thingiverse
Corner Bracket
by Thingiverse
Last crawled date: 6 years, 4 months ago
Corner bracket for use with Wyze Cam Pan Screw Wall Mount by Carbonesque.
This will fit a standard 90degree interior/exterior wall, maintains channel for cable management, has thru-holes which line up with the original screw holes in the wall mount to screw the wall mount to this adapter block - I suppose you could just sink two long screws into them and mount the corner bracket as well - I left them open for that option.
Also has two pocket recessed thru-holes for mounting the adapter into the corner. The screw holes are offset and will place the screws outside of the standard interior metal corner piece and into the paper tape.
Method for install would be to run the cable through the corner adapter first, then mount it to the wall using the offset pocket screw holes. then run the cable through the pan-cam mount and attach the pan cam mount to the adapter.
Model has built in support for the cable management overhang, snaps off.
I printed with Hatchbox PLA (for interior use) with 20% cubic infil. .28 layer height.
1 hour print on Ender 3 pro with increasing the speed - since hidden in a corner, cosmetics didn't matter to me. If they matter to you... adjust accordingly, prints really nicely in less than 2.5 hours using default .2 setting in CURA with 205/60c temps for hatcbox PLA.
This will fit a standard 90degree interior/exterior wall, maintains channel for cable management, has thru-holes which line up with the original screw holes in the wall mount to screw the wall mount to this adapter block - I suppose you could just sink two long screws into them and mount the corner bracket as well - I left them open for that option.
Also has two pocket recessed thru-holes for mounting the adapter into the corner. The screw holes are offset and will place the screws outside of the standard interior metal corner piece and into the paper tape.
Method for install would be to run the cable through the corner adapter first, then mount it to the wall using the offset pocket screw holes. then run the cable through the pan-cam mount and attach the pan cam mount to the adapter.
Model has built in support for the cable management overhang, snaps off.
I printed with Hatchbox PLA (for interior use) with 20% cubic infil. .28 layer height.
1 hour print on Ender 3 pro with increasing the speed - since hidden in a corner, cosmetics didn't matter to me. If they matter to you... adjust accordingly, prints really nicely in less than 2.5 hours using default .2 setting in CURA with 205/60c temps for hatcbox PLA.