CoreXY Calibration

Last crawled date: 4 years, 4 months ago

This procedure makes use of three calibration objects. An Extrusion Cylinder, a Calibration Octagon and a 100mm Calibration Column. This is probably not the only way to calibrate but it's the process I used when calibrating my CoreXY.
A caliper is required to perform this calibration.
There are eight steps to complete the calibration:
verify the printer's frame is square.
Level bed and adjust the Z offset.
Calibrate the extruder.
Calibrate the Extrusion Multiplier of the slicer.
Identify the Alpha and Beta stepper motors.
Using the Calibration Octagon adjust belt tension.
Using the Calibration Octagon adjust steps/mm of the Alpha and Beta Motors.
Using the 100mm column adjust the steps/mm of the Z stepper motor.
Prior to starting calibration verify that the printer's frame is square, the bed is leveled, and the Z-Offset calibrated.
These first steps are important to guarantee accurate calibration.