Connector by UserWL

...te([0,0,-59]) { difference() { cylinder(h=height, r=radius, center=center); cylinder(h=height, r=radius-wall, center=center); } }

...a_spe thingiverse universal connector. original size is 8x15x15. inner radius - 4mm, outer - 8mm. you can scale it to your sizes

...ius: 3.90 mm thread inner radius: 3.60 mm thread pitch: 0.60 mm cable hole radius: 2.00 mm housing length: 10.00mm + conus 6.60mm

...ube on side, is included on the downside rod for the holding of outer ring. you need a screw for the connection of the two parts.

...izer extreme q thingiverse designed to fit glass connectors with a 3/8ths inch outer radius, but can easily scale it up or down.

...ular connectors. note that my sma connectors were not perfectly perpendicular to the case, so there is a slight adjustment angle.

...be the correct name) of the saw. compared to the original, i added a radius on the small tube´s lower end to make it more stable.

... for the olympus ck30 light intensity control knob. possible usable with other microscopes, which have a 3 mm (radius) connector.

...w bulb mount by ikromin thingiverse just a c-ring i needed to replace for a lamp that uses an edison screw light bulb connector.

...side fits into most vacuum cleaners. if yours has a different outer diameter, you may simply scale one of the models accordingly.

...e on the rounded edge is 8.00mm. the next adjacent one is 0.10mm greater in diameter up to the last one being 8.40mm in diameter.

...he top and bottom pieces sandwich the l-bracket from the kit. you will also need four m3x25mm screws to hold everything together.

...connector by nagato thingiverse connector

...connectors thingiverse m

...bulkhead connectors thingiverse bulkhead connectors

...connector by graham2020 thingiverse connector for 6mm dowel

...connector cap thingiverse this is a cap for the connector of the optimate charger

...x-connector, cross connector thingiverse kreuzverbinder zur verbindung von drei 6 mm dicken brettchen

...t-connector, butt connector thingiverse mit den stossverbinder kann man zwei 6 mm brettchen miteinander verbinden

...erse made my own connectors for the great loop! like the idea to use the standard connector, should be more "flexible"

...turret connector by nicklasgaardh thingiverse connector for turrent