Thingiverse
Compliant SMD Magazine - Improved mouth by mattsains
by Thingiverse
Last crawled date: 4 years, 7 months ago
I made a slight improvement to the compliant holder: https://a360.co/3cXAnuq
I covered the mouth of the dispenser because I found that the wedge shaped part was in danger of snapping off.
I also reduced the size of the hole where the plastic tape cover pulls out, because I noticed that my components would fall out of that hole if I wasn't careful.
I covered the mouth of the dispenser because I found that the wedge shaped part was in danger of snapping off.
I also reduced the size of the hole where the plastic tape cover pulls out, because I noticed that my components would fall out of that hole if I wasn't careful.