Thingiverse
Coilover C spanner by woggin
by Thingiverse
Last crawled date: 5 years, 4 months ago
I wanted to adjust the height of my coilovers, and, i have no spanners. BUT, i do have a 3d printer!
And so the designing began. I havent actually tried to adjust the height, and i have doubt they will be strong enough to wind the collar up, but down shouldnt be a problem (i have been using a monkey wrench, and its quite hard with that even (winding up that is, the car does weigh 1800kg though))
but for someone with a light car, this might work, and, if u do your own aluminium casting, you can cast this in ally and have a very strong c-spanner!
i may upload a couple different sizes if this version is too small for the height adjusting collar, but it is a good size for the locking collar on my tanabe sustec pro coilovers.
And so the designing began. I havent actually tried to adjust the height, and i have doubt they will be strong enough to wind the collar up, but down shouldnt be a problem (i have been using a monkey wrench, and its quite hard with that even (winding up that is, the car does weigh 1800kg though))
but for someone with a light car, this might work, and, if u do your own aluminium casting, you can cast this in ally and have a very strong c-spanner!
i may upload a couple different sizes if this version is too small for the height adjusting collar, but it is a good size for the locking collar on my tanabe sustec pro coilovers.