Thingiverse

Coil Spring Retainer for Traxxas 1/10 Shock Absorber by nabzim
by Thingiverse
Last crawled date: 4 years, 5 months ago
I designed this replacement part for my traxxas Rustler, but I looked at many pictures online and it seems that almost all traxxas 1/10th scale vehicles use the exact same shock, just with different coil designs.
just print with supports if you can; there's a little ledge that hangs off.... I don't think Cura recognized the overhang in my prints and didn't really make any supports, but the part still works flawlessly in my Rustler.
Just use your favorite print settings; every printer is gonna have slightly different results, but I doubt they will have any effect on performance. In the photos you see a 2mm layer height, 50% density @ 60mm/s.
Make sure the flat side is down when printing. (thingiview is upside-down)
just print with supports if you can; there's a little ledge that hangs off.... I don't think Cura recognized the overhang in my prints and didn't really make any supports, but the part still works flawlessly in my Rustler.
Just use your favorite print settings; every printer is gonna have slightly different results, but I doubt they will have any effect on performance. In the photos you see a 2mm layer height, 50% density @ 60mm/s.
Make sure the flat side is down when printing. (thingiview is upside-down)