Thingiverse
Clip-on RSA Token Holder by JimE2017
by Thingiverse
Last crawled date: 4 years, 2 months ago
This is a clip-on holder for an RSA Token. The original design fits a two sided badge holder, but you should be able to customize it to fit single sided holders by adjusting the badge_width variable.
If you print the clip on it's edge, it shouldn't need any supports.
You will need to remove the key ring to install the token, and I re-installed the ring just in case the token slips out of place.
If you print the clip on it's edge, it shouldn't need any supports.
You will need to remove the key ring to install the token, and I re-installed the ring just in case the token slips out of place.