Thingiverse
Climbing Hold 4 by calcuttcustomeng
by Thingiverse
Last crawled date: 4 years, 3 months ago
Another intermediate hold. Uses an M10 SHCS fastener. I have load tested it under my own weight and it performs great.
This hold features a pocket and a small crimp/pinch area.
I would not recommend printing anything less than 100% fill if the intended use is for climbing. Use at your own risk! (however I did stress analysis on all my holds so there is a degree of confidence in the design)
This hold features a pocket and a small crimp/pinch area.
I would not recommend printing anything less than 100% fill if the intended use is for climbing. Use at your own risk! (however I did stress analysis on all my holds so there is a degree of confidence in the design)