Chorus RF laptimer case by DAquad

Last crawled date: 4 years, 1 month ago

I love racing my quadcopters and always wanted a good lap timer that it is easy to operate.
I came across this great project Chorus RFlaptimer by Andrey Voroshkov and decided to design a case which will be small, easy to install and use.
For instructions on how to build one Chorus RF lap timer, please refer to https://github.com/voroshkov/Chorus-RF-Laptimer
Here is where I got my parts from in case you want to support my design efforts (:
1 pcs Arduino Nano: http://bit.ly/arduinon
1 pcs Rx5808: http://bit.ly/rx5808vtx
1 pcs BT module: http://bit.ly/hc06bt
1 pcs 5v Bec:http://bit.ly/5vbec
1 pcs 2S Lipo 1500mah : http://bit.ly/2s1500mah
1 pcs Piezzo Buzzer: http://bit.ly/Piezzo
1 pcs 1K Resistor ,1 pcs 10K Resistor: http://bit.ly/resmix
1 pcsBreadboard http://bit.ly/breadcopper
Transparent PLA: http://bit.ly/platrans
4 Pcs 4mm1.5mm Magnets: http://bit.ly/magnets4mm
4 Pcs M330 Allan: http://bit.ly/m3allan
1 pcs XT60 connector: http://bit.ly/xt60con
Hot glue gun: http://bit.ly/hotgunglue
3D printer Tevo Tarantula like mine: http://bit.ly/3dprintertevo
Xiaomi mi6 the phone I use to connect to the lap timer: http://bit.ly/myphonemi
***Cut the breadboard to 46mm to fit in the case
***Put the electronic components on breadboard to fit holes in the case
***I use 2s 1500Mah Lipo if you use different one PM me
I included magnets in case you want to add more modules, You can up to 8. Check Chorus RF page on how to do it!