Thingiverse
Choke knob and control arms for DLE and similar RC gas engines by tfrancis
by Thingiverse
Last crawled date: 4 years, 7 months ago
Various choke solutions for DLE and similar gas RC motors
The choke knob r3.stl and choke r3.stl need to be connecred together via a 2.5 to 3 mm wire bent to 90deg at each endthat is glued into place
The levers (control arms) can be used with a servo or manual control rod, the rod size is 2mm
The choke r3.stl and the levers use 2mm bolts to connect to the carburator, 2.5mm can be used but will need to be drilled out.
The levers can be used on some throttle setups as well but may need to be modified
Print with ABS, ASA or other higher temp fillaments, pla may work depending on engine cooling.
Supports are needed, print at 0.15mm or 0.2mm layers and 100% infill
My 123design files are included
The choke knob r3.stl and choke r3.stl need to be connecred together via a 2.5 to 3 mm wire bent to 90deg at each endthat is glued into place
The levers (control arms) can be used with a servo or manual control rod, the rod size is 2mm
The choke r3.stl and the levers use 2mm bolts to connect to the carburator, 2.5mm can be used but will need to be drilled out.
The levers can be used on some throttle setups as well but may need to be modified
Print with ABS, ASA or other higher temp fillaments, pla may work depending on engine cooling.
Supports are needed, print at 0.15mm or 0.2mm layers and 100% infill
My 123design files are included