Celestron Raspberry Pi Sleeve Remix by jpod

Last crawled date: 4 years, 1 month ago

This is a basis of a PiAstroHub telescope controller for a Celestron CPC11, though it should fit other models. The remix includes a Raspberry Pi sleeve that adds 'L' shaped clips on the top and bottom, allowing for additional mounting of accessories. Included is a circular base that fits on the bottom to set the whole kaboodle in a the 1.25" eyepiece holder that is part of the Celestron telescope mount. Also a WiFi access point clip for TimeTec PR30M2P nano access points, like this:http://www.amazon.com/Timetec-Wireless-Portable-Broadband-Ethernet/dp/B00DES74YU/ref=sr_1_1?ie=UTF8&qid=1425870571&sr=8-1&keywords=PR30M2P
Note the clip-on pieces are a tight friction fit, design to not require any glue. You may have to lightly tap the pieces into the slot using a smaller hammer or rubber mallet. You'll probably never get them apart, but then, why would you want to?