Thingiverse
Catamaran for hover:bit by MakeKit
by Thingiverse
Last crawled date: 5 years, 1 month ago
See video tutorial: https://www.youtube.com/watch?v=mjkiQWbEbqw
5-10% infill on floaters for low weight. Can be a bit higher on the center base plate.
If you have good bridge settings you can try printing without support for the floaters. (Printed upside down)
Check for water sealing before running on open water. Subdrain in a sink and see if water goes inside. Don´t let it stay in the water for more than 30 min to prevent water to get in.
5-10% infill on floaters for low weight. Can be a bit higher on the center base plate.
If you have good bridge settings you can try printing without support for the floaters. (Printed upside down)
Check for water sealing before running on open water. Subdrain in a sink and see if water goes inside. Don´t let it stay in the water for more than 30 min to prevent water to get in.