Thingiverse
Cat 5/6 one peice Cable Clamp by Extkits
by Thingiverse
Last crawled date: 4 years, 1 month ago
Cat5 or Cat6 or any 7-8mm diameter cable clip. Designed for walls where P-clips wont work. Hammers directly into a 5mm hole.
Use:
After printing DO NOT REMOVE THE HOLE CENTRE.
Drill a 5mm hole into brick or concrete with a masonry drill/bit.
Hammer in the clip with the small gap facing upwards, then remove the centre from the clip and clip in the cable .
Printing:
Printed in 1.75mm ABS filament via 0.4mm nozzle using ENDER3 sliced in CURA
CURA Settings.
1.6mm layer height,
1.4mm wall thickness,
20% infill,
No build plate adhesion,
No Support.
No Rafts
Otherwise defaults.
Other settings to suit your filament.
Only tested in ABS, but other filaments should work fine, but may be softer.
Use:
After printing DO NOT REMOVE THE HOLE CENTRE.
Drill a 5mm hole into brick or concrete with a masonry drill/bit.
Hammer in the clip with the small gap facing upwards, then remove the centre from the clip and clip in the cable .
Printing:
Printed in 1.75mm ABS filament via 0.4mm nozzle using ENDER3 sliced in CURA
CURA Settings.
1.6mm layer height,
1.4mm wall thickness,
20% infill,
No build plate adhesion,
No Support.
No Rafts
Otherwise defaults.
Other settings to suit your filament.
Only tested in ABS, but other filaments should work fine, but may be softer.