Thingiverse
Cat 5 Network Cable mount by rizkypratama
by Thingiverse
Last crawled date: 4 years, 7 months ago
My Cat5E is 5.5mm in diameter, i dont know how many other brands diameter are. so if yours is close this would work for you.
Updated with <8mm cable diameter mount.
Use a small Cable ties or the hole might not fits.
Print speed 60mm/s or slower.
Nozzle 0.5mm or lower should be ok i printed mine using 0.5mm nozzle
Layer 0.28mm.
It printed fine without support.
Infill 20% (probably doesnt matter much as this is such a small print)
Wall 3 layers
Top/bottom 3 layers
This mount was designed for Double sided tape with 24mm width so you just need to cut length-wise. I am using 3M VHB Tape 24mm width as in the picture.
Updated with <8mm cable diameter mount.
Use a small Cable ties or the hole might not fits.
Print speed 60mm/s or slower.
Nozzle 0.5mm or lower should be ok i printed mine using 0.5mm nozzle
Layer 0.28mm.
It printed fine without support.
Infill 20% (probably doesnt matter much as this is such a small print)
Wall 3 layers
Top/bottom 3 layers
This mount was designed for Double sided tape with 24mm width so you just need to cut length-wise. I am using 3M VHB Tape 24mm width as in the picture.