Thingiverse
Cap Brim Flashlight Mount - 25.4, 28, 30, & 34mm at 15degrees by Palmtopper
by Thingiverse
Last crawled date: 4 years, 10 months ago
Flashlight brim holder for 25.4mm/1", 28mm, 30mm, and 34mm flashlights. It has a bit of room to clamp down for flashight sizes <~1mm in range.
Reinforced the joints, and added a 15 degree angle for a better angle for your flashlight to point down at.
*Added small teeth to the inside of the brim clamp for better hold.
*Made the screw a tad smaller so it'd fit in the hole easier, and changed to a tightening with a coin. (it's pretty friction fit already, you probably don't need the screw unless you really want it secured)
*Added extra reinforced version of 15degrees using thicker clamp and also skeletonized it for extra walls during print.
Reinforced the joints, and added a 15 degree angle for a better angle for your flashlight to point down at.
*Added small teeth to the inside of the brim clamp for better hold.
*Made the screw a tad smaller so it'd fit in the hole easier, and changed to a tightening with a coin. (it's pretty friction fit already, you probably don't need the screw unless you really want it secured)
*Added extra reinforced version of 15degrees using thicker clamp and also skeletonized it for extra walls during print.