Cannula extension by Vandelay7

...suction cannula holder by docbefa thingiverse disposable succion cannula holder diameter 65 mm

...in natural pla and the cap in orange pla it looked very effective on stage. picture is of version 1 before i made a separate cap.

...e nose. note: i am not a doctor and this should only be used as a last resort. use at your own risk and under close supervision.

...s not been implemenetd - more work is needed to make this better. consider helping if you'd like (join the hackaday project).

...s of precious oxygen. please refer images showing various configurations, parts and setups etc. good luck to everyone involved.

...oduct/product&product_id=51 m3 thumb screws: https://www.mcmaster.com/92558a310/ my lab uses black ceramic 1.25 mm ferrules.

...dial indicator extension tip by zumbefin thingiverse extension tip for dial indicator. extension is about 13mm

...tail extension thingiverse this is a tail extension for binary.

...clip extension by dgw277 thingiverse clip extension

...f extension 2 -> without rifling nerf extension rifled2 -> with coolings if there is any problem, please contact me

...in natural pla and the cap in orange pla it looked very effective on stage. picture is of version 1 before i made a separate cap.

...suction cannula holder by docbefa thingiverse disposable succion cannula holder diameter 65 mm

...s not been implemenetd - more work is needed to make this better. consider helping if you'd like (join the hackaday project).

...e nose. note: i am not a doctor and this should only be used as a last resort. use at your own risk and under close supervision.

...oduct/product&product_id=51 m3 thumb screws: https://www.mcmaster.com/92558a310/ my lab uses black ceramic 1.25 mm ferrules.

...er pellets of 5mm diameter. [printed part was glued as another part failed within the same print and had to be reprinted in part]

...are various configurations possible, e.g direct cylinder to nasal cannula (note: cannula fits directly on ro pipe) direct cylinder...

...is also suitable for copd patients with a nasal cannula for oxygen. life without a 3d printer is possible,...

...adapter hose that would attach medline supersoft adult nasal cannula (part # hcsu4514s) to a regular oxygen hose. instead...

...tail extension thingiverse this is a tail extension for binary.

...clip extension by dgw277 thingiverse clip extension

...extension leads 48mm thingiverse extension leads 48mm

...gopro extension by mbremer thingiverse gopro extension mount

...t a further reach. only takes about an hour to print. also when not in use this would be able to protect the prongs on your cord.

...extension for vacuum by texano thingiverse extension for vacuum cleaners for small areas such as car

...rse this is just a simple extension holder and organizer works best with 1/2 and 3/8 in extensions but will hold 1/4 in as well.

...ension http://www.thingiverse.com/thing:833924 it's the exact same but i extended the bottom a bit to accomodate my gimbal.

...sion gopro :)https://www.youtube.com/watch?v=vfsx25r7owo blind nut m5. https://www.facebook.com/pages/datheus/289941987825883

...throttle lever extension thingiverse throttle lever extension for saito fa-40 https://youtu.be/bnjgwzeo5ty