Camera 2: Cinema-style camera housing for Raspberry Pi 4 and HQ camera by edgett

Last crawled date: 3 years, 1 month ago

This is an actively-cooled cinema-style camera housing for a Raspberry Pi 4B and a Raspberry Pi HQ Camera that features a 45* articulating LCD touch screen, mounting for external accessories, as well as space for a high-capacity battery.
If you are looking for software to run on this camera, consider this camera software that includes on-screen controls and raw image capture.
Getting Started
You will need the following non-included parts:
(1) - Raspberry Pi 4B
(1) - Micro SD card (Sandisk preferred)
(1) - USB Storage Device (Sandisk or Samsung preferred)
(1) - Raspberry Pi HQ Camera
(1) - Adafruit Flex Cable for Raspberry Pi Camera or Display - 300mm / 12"
(1) - Set of 20cm Male to Male Jumper Wires
(1) - Waveshare 5.5" Capacitive Touch LCD with DSI Connector
(2) - Noctua 40mm x 10mm 5-volt Fans
(1) - Noctua Y Splitter Cable
(1) - 40mm Fan Grill/Guard
(1) - Assorted Camera Screws
(1) - Left and Right set of Torque Friction Type Positioning Hinges
(1) - Set of M3, M4, M5 Cap Head Screws
(1) - Set of assorted M2.5 Cap Head Screws
(3) - Assorted 1/4-20 Cap Head Screws, Nuts, and Washers
(4) - M2.5 x 35mm Cap Head Screws
(1) - M6 Stainless Threaded Stud with Thrust Pad
(5) - Black round rubberized padded "feet"
(4) - 5.9mm x 4mm Neodymium Disc Magnets
(1) - Aluminum Heatsink Set
(1) - Anker PowerCore Essential 20000 PD battery
(1) - CS Lens or other lens with C or CS mount adapter
You may need the following additional tools:
1/4"-20 tap set
Metric tap set
Needle nose pliers
Xacto Knife (for cleaning up small imperfections in prints)
WD-40 (for lubricating threads of fasteners)
Gorilla Glue gel