Thingiverse
Caliper Addon for Ruler Remix by dama-gomez
by Thingiverse
Last crawled date: 4 years, 3 months ago
Made a remix to fit my flat all metal ruler (29mm width and 1mm depth)
Designed by Rollerpaw
Photos are of v01 files, but didn't realize until after i printed that the End slot was 0.95cm and not 1cm in length.
Since my ruler starts at 0, it would be a bigger pain to substract 0.95cm than 1cm, therefore V02 comes in with improvements on size and a small grip to move around the slider.
Did not print V02 yet, but should be more precise.
In my case i turned on bridge mode on Cura and did not need any support at all.
It fitted in perfect after print, hassle free.
Hope this remix works for someone else!
Thank you Rollerpaw!
saved me big bucks in having to buy one.
Designed by Rollerpaw
Photos are of v01 files, but didn't realize until after i printed that the End slot was 0.95cm and not 1cm in length.
Since my ruler starts at 0, it would be a bigger pain to substract 0.95cm than 1cm, therefore V02 comes in with improvements on size and a small grip to move around the slider.
Did not print V02 yet, but should be more precise.
In my case i turned on bridge mode on Cura and did not need any support at all.
It fitted in perfect after print, hassle free.
Hope this remix works for someone else!
Thank you Rollerpaw!
saved me big bucks in having to buy one.