Bugsy Jr, Micro Quadcopter, Baby 250 by PeculiarDesigns

Last crawled date: 3 years, 1 month ago

Bugsy Jr. was made with one real purpose in mind, to look adorable next to a typical 250 quad. However, it turns out he is a proper quad in his own right!
Keep in mind, this is a fragile little guy. The main plates are only 1mm thick, and depending on the material used can crack easy. On the upside, it is quite fast to print more.
Currently I get ~5 min of flight time going easy on it.
Print using a rigid filament, particularly for the arms, to reduce vibration/noise issues
Print List:
Main Plate (2)
Arm (4)
Top Plate (1)
MotorSpacer(4) (TPU)
BatteryStrap(2) (TPU) - Narrow straps fit bottom battery mount slots as well as top
Camera Mount(2) (TPU) Print the mount twice, one time Mirrored
Parts List(as Pictured):
0703 10000kv Motors (4)
Betaflight F3 Micro 6A 2S 4-In-1 Brushless ESC OSD Flight Controller Micro Cube
XT30 Battery cable
Makerfire 350mAh 60C 2S 7.4V Lipo
Props: 55mm, 60mm should fit, haven't tried yet
Hardware:
M2 Nylon assortment, designed for 15mm standoffs between top and main plate
History:
12/06/17 - Fixed a misplaced mounting hole in top plate
12/02/17 - Further updated arms, nubs on end to protect motors. Re-oriented arm screw holes to help prevent them getting ripped out in a forward collision.
11/30/17 - Stronger arms, much less vibration. Modified main plate for passing wiring between plates. Replaced original top plate with notched plate, modified holes for AIO camera.
11/26/17 - Updated screw hole sizes on everything to reduce slop in arms and body. Use a 2mm or 5/64 bit to clean up holes as necessary. Added Narrow Battery straps and strap holes to main frame for bottom mounted battery.
11/25/17 - Added the camera mount
11/25/17 - Added a top plate with a slight front notch for FPV view
11/25/17 - Added Feet! Top plate hole for camera buttons.
11/24/17 - Initial Upload