Thingiverse
Bread lame by ryanEckert
by Thingiverse
Last crawled date: 4 years, 4 months ago
A simple bread lame based on the UFO lame
The razor blade can be stored between the two halves for safe-keeping when not in use.
Additional items required:
Razor blade
M3-0.5 nut
M3-0.5 x 8mm cap head machine screw
Hardware I used
Additional info:
The fit for the nut and bolt is very tight. The nut can be pressed in, and the bolt will need to be threaded in. This makes it so the lame can be unscrewed without tools after initial setup.
.obj & .f3d files included if you need to make adjustments for different hardware, etc.
Built in Fusion 360
UPDATE
27.12.20
Threading on 3 mm bolts tends to snag the razor, making it difficult to insert/pull out.
I updated with .stl files to accommodate 2.5 mm hardware.
I have not tested these, but they should fit.
The razor blade can be stored between the two halves for safe-keeping when not in use.
Additional items required:
Razor blade
M3-0.5 nut
M3-0.5 x 8mm cap head machine screw
Hardware I used
Additional info:
The fit for the nut and bolt is very tight. The nut can be pressed in, and the bolt will need to be threaded in. This makes it so the lame can be unscrewed without tools after initial setup.
.obj & .f3d files included if you need to make adjustments for different hardware, etc.
Built in Fusion 360
UPDATE
27.12.20
Threading on 3 mm bolts tends to snag the razor, making it difficult to insert/pull out.
I updated with .stl files to accommodate 2.5 mm hardware.
I have not tested these, but they should fit.