Box for Soldering Heat Gun from CD-ROM housing by Jilativ

Last crawled date: 4 years ago

Box for hot air soldering gun from CD-ROM housing
Using CD-ROM housing and printed front and back panels.
Model back panel with 2 different 220V connector from ATX power supply.
This is the last part on my homemade soldering station.
In this parts i added sidebars for the assembly of 3 parts cd-roms, holder for soldering tip and hot air soldering gun holder. In hot air soldering gun holder have a magnets.
I used soldering gun from Lukey with motor on 24V. Homemade control board and front panel board. The + / - / MR buttons from the calculator.
!The case is isolated from the circuit dielectric spacers!
Added scheme and firmware. (http://radiokot.ru/forum/viewtopic.php?f=25&t=44436)
Specification for front and back panels:
Soldering Heat Gun Handle - https://letyshops.com/r/aliexpress-ww-dc68472fbbd2
GX16 8 Pin Male & Female - https://letyshops.com/r/aliexpress-ww-c38b2fa62684
1pcs Switch ON/OFF 220V - https://letyshops.com/r/aliexpress-ww-72259d6de8be
3pcs Push Button Switch - https://letyshops.com/r/aliexpress-ww-cb29984ed30e
2pcs 220V connector (i'm using from ATX Power supply Male & Female)
1pcs 7 segment led - https://letyshops.com/r/aliexpress-ww-421dd8c555fc
11pcs Nuts M3 - https://letyshops.com/r/aliexpress-ww-1bb7d3bd1ab3
Other nuts and screws
Other project "Box from CD-ROM housing":
http://www.thingiverse.com/thing:1995138https://www.thingiverse.com/thing:2149127https://www.thingiverse.com/thing:4537745https://www.thingiverse.com/thing:1965947
Update 10.07.20
Now it is modular construction. Added 2 modules (side and top) for assembly all boxes and ramping up in future.