Bowden tube feeder with filament release mechanism - 3mm version by kert

Last crawled date: 3 years ago

UPDATE 1 :
I made a little approximation modifying the top plate, and made the space for the 8mm Bearing too narrow for it to really push the filament against the hobbed bolt without touching the surrounding walls. I just corrected this so if you printed the previous version, you might need to use a dremel or a knife to remove some matter.
I absolutely loved the design by satoer, and I definitely wanted this bowden mechanism on the printer I'm building!
Unfortunately, it is only available for 1.75mm filament, so I had to redesign the meshs. But here it is, it is fully functionnal, and it adjusts just as it should!
I made several other modifications :
adapted to my setup, I wanted to use a M8 ball bearing (didn't want to buy a new smaller one) so the whole box is a bit larger
I use a hobbed bolt, not a crancked gear, so I had to modify the hole in "top" for it to fit
I use a Nema14 with a gearbox, so the screw spacing is not the same
and finally, I of course modified the holes for the 3mm filament to fit ^^
Hope it gets usefull for someone around here.
Let me know if you make it! :)