Thingiverse
Bowden Clamp for M10
by Thingiverse
Last crawled date: 5 years, 6 months ago
Reworked from j0achims great clamp for sta.ndard M6 Creality Ender 3 insert.
Now fits the M10 Supplied Extruder Insert
Scale to 101% and print upright hex facing up. Support only between the arms. Block support
where the m4 bolts go above and below. Clear support after
Gcode for ender 3
3mf cura project supplied.
May need to work at the hole for PTFE tube, i used nail scissors.
First screw in the insert to the extruder.
Push the tube into the clamp (use a flat head scew driver to widen the gap). A bit fiddly.
Pull the tube through and into extruder insert.
Slide clamp onto insert with the hex fit.
Use m4 bolts and nuts to tighten
Now fits the M10 Supplied Extruder Insert
Scale to 101% and print upright hex facing up. Support only between the arms. Block support
where the m4 bolts go above and below. Clear support after
Gcode for ender 3
3mf cura project supplied.
May need to work at the hole for PTFE tube, i used nail scissors.
First screw in the insert to the extruder.
Push the tube into the clamp (use a flat head scew driver to widen the gap). A bit fiddly.
Pull the tube through and into extruder insert.
Slide clamp onto insert with the hex fit.
Use m4 bolts and nuts to tighten