Bosch 1611 Fan by Anejocola

Last crawled date: 3 years ago

Routers operate at high rpm, making this is at your own risk. (disclaimer)
Not approved, endorsed or affiliated with Bosch.
This fan is to replace the obsolete part 3606610517, internal cooling fan. Design was derived from parts remaining in the housing after factory part failure. *Remixed the fan, due to weak mating at the outer rim joint.
The two piece hub section meets over the factory hex remaining once plastic fan is removed. There is a ridge that faces the collet, or away from the windings.The hubless fan is glued over this hub, flush at the top. Allow to remain overnight.
*The nut tool is optional, I saw a screwdriver used in avideo for bearing replacement on this same tool. But the printed tool works pretty slick. :)