Thingiverse
Boilie Shot ( Nash Cybershot Clone) by ripper121
by Thingiverse
Last crawled date: 4 years, 6 months ago
This is my Clone of the Nash Cybershot.
You need:
30cm of M25 installation conduit
1-2 Meter of 8mm aluminum pipe
Printed with Ultimaker PLA (Inofil3D) 110% extrusion Rate
Model Size 102% in Cura
Update: Added some suport walls to V5, so there is no edge bending.
After you print it you can remove the support walls
You need:
30cm of M25 installation conduit
1-2 Meter of 8mm aluminum pipe
Printed with Ultimaker PLA (Inofil3D) 110% extrusion Rate
Model Size 102% in Cura
Update: Added some suport walls to V5, so there is no edge bending.
After you print it you can remove the support walls