Blue Dog V3 : Unibody Quadcopter by shubhamAT

Last crawled date: 3 years ago

I designed this Quadcopter with the intention of making it quicker to assemble than other DIY kits. Here are the features:
ARMS
4 Arms and Main plate form a single structure. No need to bolt the arms and main plate together.
Arms desgined for 3100KV Motor with 5 MM shaft and M2 screws
Arms have 2 pairs of slots for routing a cable tie.
40 MM max width of arm to accomodate upto 6A ESCs
Arm thickness is 2 MM supported by a 5 MM wide and 10 MM thick under skirt. Skirt adds rigidity to the arms while also acting as a landing gear with wide load distribution.
Main Plate
60 MM wide and 200 MM long main plate for placing Micro FPV camera, VTX, FC, RX and a 2S battery in the same plane
18 M3 holes evenly spread across the body for mounting accessories. Outer holes form a 30.5 square for mounting a CC3D board.
Horizontal slits for rounting wires and velcros.
Supported by 5MM wide and 10 MM thick under skirt. Adds rigidity to the 2 MM thick plate while also acting as a landing skid.
Accessories:
10 Degree tilted FPV Camera Mount
Tail for adding an Rx or its antenna
Note that this is intended to be a not-fast quadcopter: aimed at FPV beginners. My goal is to create something like a Blade 180 QX with the power of brushless motors. I will be assembling this on my own when the print is ready.