Thingiverse
Bitmain PSU Vertical Holder by Phate
by Thingiverse
Last crawled date: 4 years, 6 months ago
A simple vertical PSU holder for Bitmain's PSU.
Bitmain PSU 1 STL file is for the older APW3-12-1600
Bitmain PSU 2 STL file is for the newer APW3+-12-1600
Pictures are all of the older PSU's.
The cable tie groove and the split for squeezing the top of holder tight is not really needed. The PSU's are secure without them.
The metal shelf/mesh has a square spacing of 50mm
This was designed in sketchup and all printed on a Flashforge Dreamer.
I used the standard low quality settings in FlashPrint.
Happy enough with quality so did not treat with acetone.
About a 6 hour +- print.
Please excuse any amateur mistakes..... this is my first fully from scratch design...
But I hope this helps someone.... Enjoy :-)
Bitmain PSU 1 STL file is for the older APW3-12-1600
Bitmain PSU 2 STL file is for the newer APW3+-12-1600
Pictures are all of the older PSU's.
The cable tie groove and the split for squeezing the top of holder tight is not really needed. The PSU's are secure without them.
The metal shelf/mesh has a square spacing of 50mm
This was designed in sketchup and all printed on a Flashforge Dreamer.
I used the standard low quality settings in FlashPrint.
Happy enough with quality so did not treat with acetone.
About a 6 hour +- print.
Please excuse any amateur mistakes..... this is my first fully from scratch design...
But I hope this helps someone.... Enjoy :-)