Thingiverse
BISSELL 1132 Symphony Latch by Cowtippin86
by Thingiverse
Last crawled date: 4 years, 5 months ago
This is to replace the "BO FOOT LATCH HOOK" that is on a BISSELL 1132 Symphony™ All-In-One Vacuum and Steam Mop. It is the key piece that holds the mop head to the base. They do not sell this as a replacement part on their website.
Molded this in TinkerCad using a digital caliper and the broken part as reference. Tolerances are tight for a good fit.
Supports are not really needed but it helps the tabs keep their round shape. I just painted them on in Pursa Slicer and applied by enforcers.
Printed at .1mm, 5 top and 5 bottom shell layers, 100% infill.
For the supports I put the z contact distance at .25mm.
Printed in cheap filament I bought off Amazon.
Nozzle temp @205 for the first layer and 203 for other layers. (Using a micro swiss hot end on ender 3 v2.)
Bed temp 60 for first layer and 57 for other layers.
Retraction length 5mm.
Z lift .3mm.
Print time was just over an hour.
Molded this in TinkerCad using a digital caliper and the broken part as reference. Tolerances are tight for a good fit.
Supports are not really needed but it helps the tabs keep their round shape. I just painted them on in Pursa Slicer and applied by enforcers.
Printed at .1mm, 5 top and 5 bottom shell layers, 100% infill.
For the supports I put the z contact distance at .25mm.
Printed in cheap filament I bought off Amazon.
Nozzle temp @205 for the first layer and 203 for other layers. (Using a micro swiss hot end on ender 3 v2.)
Bed temp 60 for first layer and 57 for other layers.
Retraction length 5mm.
Z lift .3mm.
Print time was just over an hour.