Thingiverse
BIGTREETECH TFT24 V1.1 by Baptist
by Thingiverse
Last crawled date: 4 years, 9 months ago
I designed this enclosure mount for my new BIGTREETECH TFT24 V1.1 display. This is fixed but could be removed quite easily also rotated up 30 degrees
The rear stand can be screwed to the printer.The enclosure then clips to the stand panel (this quite tight to ensure it remains in place). The reset button is flush with the front, to avoid any any accidental resets when rotating the dial.
Link to display.. https://www.aliexpress.com/item/33048619460.html?spm=a2g0s.9042311.0.0.27426c37cWHMXV
When printing you might have to rotate in the slicing software to make it flat on the bed.
No supports needed.
The rear stand can be screwed to the printer.The enclosure then clips to the stand panel (this quite tight to ensure it remains in place). The reset button is flush with the front, to avoid any any accidental resets when rotating the dial.
Link to display.. https://www.aliexpress.com/item/33048619460.html?spm=a2g0s.9042311.0.0.27426c37cWHMXV
When printing you might have to rotate in the slicing software to make it flat on the bed.
No supports needed.