Thingiverse
BfB3000 Vertical spool holder by Anar
by Thingiverse
Last crawled date: 4 years ago
This thing is a 50mm diameter spool holder for vertical mount on a BfB3000 (or BfB Touch hopefully).
Inspiration comes from Gael Langevin so I want to thank him for that.
Under the exact same slicing conditions, this derivative uses :
much less plastic (28.58 cm3 instead of 49 cm3)
and much less time to print (2h48mn instead of 5h18mn)
And I believe it should be pretty much as strong (but I haven't tried Gael's design).
The 2 parts will fit together using 2 screws (5mm in diameter).
I also made a derivative that will fit the Ultimaker3 (see "derivatives").
Inspiration comes from Gael Langevin so I want to thank him for that.
Under the exact same slicing conditions, this derivative uses :
much less plastic (28.58 cm3 instead of 49 cm3)
and much less time to print (2h48mn instead of 5h18mn)
And I believe it should be pretty much as strong (but I haven't tried Gael's design).
The 2 parts will fit together using 2 screws (5mm in diameter).
I also made a derivative that will fit the Ultimaker3 (see "derivatives").