BFB 3D Touch & 3000 Snap-on Fan Ducts - Simple Design by tetralite

Last crawled date: 2 years, 12 months ago

Inspired by http://www.thingiverse.com/thing:33494
Final uploads: 27 January 2014
(If you downloaded before that date you don't have the latest and greatest revisions.)
What they are...
Two snap-op fan ducts for the BFB 3D Touch and BFB 3000 printer. (Not tested for clearances on the BFB 3000.) One duct fits a single fan and the other fits two side-by-side fans. On a 3-head 3D Touch there are three 60mm fans, two on the front of the carriage and one on the back. I'm not sure if there is always a single fan per extruder head on models with one or two heads, but the single and dual ducts have it covered regardless.
My goal was to make these fan ducts completely snap-on and printable without support. After some trial and error I came up with this fairly simple design that snaps nicely and firmly into place. The walls are just 1mm thick all around, so they don't use up much material.
I tried adding snap-on deflectors at the outlets of the ducts that would tend to force the airflow down toward the tip of the hot ends, but after trying it with and without them, I decided not to use them.
Files included: .stl and .sldprt. One of the .stl files contains both ducts for printing both at a time.