Thingiverse
Beat Saber Block/Note
by Thingiverse
Last crawled date: 6 years, 5 months ago
Here are the notes from Beat Saber. I printed this on the Ender 3 and it required a little bit of sanding to fit. Be sure to print with a smaller than .2 mm size, as it wont fit otherwise.
Another tip, (since this is my first model) try to print the arrow scaled just a little bit smaller so the clearances are right and it will fit.
The block wont need supports if you have the arrow side facing up when printing.
Another tip, (since this is my first model) try to print the arrow scaled just a little bit smaller so the clearances are right and it will fit.
The block wont need supports if you have the arrow side facing up when printing.