Thingiverse
Battlestar Galactica Viper Toy size by polishviking
by Thingiverse
Last crawled date: 4 years, 1 month ago
This is a remix of the 3/34 sized viper fromhttps://www.thingiverse.com/thing:4383744. I shrunk the files and modified the upper and lower fuselage. I also modified the canopies a little. On my printer they did not come together quite right.
I also added the landing gear fromhttps://www.thingiverse.com/thing:4550223
the landing gear was also shrunk down and resized to fit both the smaller files in here and also to fit the Toy Mattel viper replacing the wheels. I found the print came out best if you sliced the landing gear in half and printing it in two pieces. When I printed them as one piece, some of the landing gear would break off when removing the supports.
After making several of these, I found at the smaller size, 100% infill worked the best. The screw holes where you join the pieced together would often break, along with some of the prints when removing supports. The missile launcher needs a little attention. I think by just making the missile longer, it will grab the missile. I used the spring out of an ink pen for the missile launcher.
I also added the landing gear fromhttps://www.thingiverse.com/thing:4550223
the landing gear was also shrunk down and resized to fit both the smaller files in here and also to fit the Toy Mattel viper replacing the wheels. I found the print came out best if you sliced the landing gear in half and printing it in two pieces. When I printed them as one piece, some of the landing gear would break off when removing the supports.
After making several of these, I found at the smaller size, 100% infill worked the best. The screw holes where you join the pieced together would often break, along with some of the prints when removing supports. The missile launcher needs a little attention. I think by just making the missile longer, it will grab the missile. I used the spring out of an ink pen for the missile launcher.