Battlestar Galactica Cylon Bust

Last crawled date: 6 years, 2 months ago

I wasn't sure if this would print, as some of the walls are a bit thin and the details close to the surface, but it didn't turn out too bad.
I used 10% infill and supports, and raft is not needed.
The LED insert, I drilled a hole through to the head and that's it, angle inward and through you go, and the best part, if the head snaps off when you are drilling, you can use that mistake to make the wiring easier before you glue it back on.. (...in theory of course... that didn't happen to me.. cough..)