Thingiverse
Basic Spool Holder by MegaAndy
by Thingiverse
Last crawled date: 5 years ago
This is a very basic spool holder to fit a 52mm spool.
The inside is a tight fit for a 308 bearing so will likely need sanding and pressing in.
It is angled so can fit slightly varying spool sizes by a few mm. largest diameter 55mm smallest 49mm so should fit spools between this.
The inside is a tight fit for a 308 bearing so will likely need sanding and pressing in.
It is angled so can fit slightly varying spool sizes by a few mm. largest diameter 55mm smallest 49mm so should fit spools between this.