Basic ESC Cover for KISS 24a and others by LVNeptune

Last crawled date: 4 years ago

Designed a super basic ESC cover because I chopped my signal wires in a crash so I figured this would be a little better. Some have been designed with tabs or whatnot to clip it into place. Crashes are unpredictable. I recommend taping this down with either electrical tape or some self-sealing tape or even just use heatshrink around it. I made it slightly bigger than the KISS 24a ESC's that I put on an X-Labs Shrike. Hope this is useful for someone.
Printed in TPU. Can use other filaments but the rubbery and absorption properties of TPU seems best to me.
UPDATED: Added some vents on one side of the ESC where your FETs are to help give them some airflow. The majority of the heat is generated from the FETs and once air hits them it will disperse through the front and rear openings depending on how you mount it.